This one might be a bit of a challenge as it is in a pretty poor state and is missing the piston and cylinder. If I can get the dimensions of the piston/cylinder then I will make them. I will post a question on the Mamod Forums in the next few days asking for dimensions. The burner is present but the burner pipe looks a bit chavelled and I think it should have a bit on the end. The firbox paint job is not too bad but the crankshaft/portblock braket is quite badly rusted. There is the remains of a transfer on the base but again the base itself is very rusted. I'm going to have to give up my day job to get all my steam engine projects finished, but then I wouldn't have the money to buy engines would I..... Life's a bitch..